Longero Rolling Capabilities
Every item is rolled to a radius or diameter. If you don't know either; one of the following pieces of information is required to determine the radius:1. Chord and mid height
2. Arc length and chord
3. Mid height and arc length
4. If shape is an ellipse:
a. Major diameter
b. Minor diameter
Angle Iron
Leg Out: Specify inside diameter and if unequal, which is leg out
Leg In: Specify inside diameter and if unequal, which is leg in
Heel Out: Specify inside diameter
Heel In: Specify outside diameter
Beams
EZ Way: Specify diameter of web C/L
Hard Way: Specify I.D. or O.D.
Channel
EZ Way Flanges Out: Specify inside diameter
EZ Way Flanges In: Specify outside diameter
Hard Way of Web: Specify I.D. or O.D.
Tees
Stem Out: Specify inside diameter
Stem In: Specify outside diameter
Stem Up: Specify diameter of stem C/L
Zee Bar
EZ Way: Specify diameter or web C/L
Rectangular Tubing
EZ Way: Specify I.D. or O.D.
Hard Way: Specify I.D. or O.D.
Flat Bar
EZ Way: Specify I.D. or O.D.
Hard Way: Specify I.D. or O.D.